Skip to main content

Ice Tube Clock


Our project leader brought in an Ice Tube Clock kit for the group to improve its soldering skills.


We followed the Adafruit instructions on how to assemble the board together. Each person took turns soldering the parts onto the board. Only a little problem occurred, which was resolved later. The problem was that the 7805 5V regulator chip wasn't placed properly on the board. Fortunately, one member was able to de-solder the chip.

Goal
  • Assemble the Ice Tube Clock kit

Comments

Post a Comment

Popular posts from this blog

Summer 2 Internship 2018

07/05/2018 Zachary managed to finish redesigning the extending claw. While the overall mechanism is now smaller than the original, it still has some of the same issues; the claw itself is too bulky and two motors may be needed to raise or lower the arm. After building the prototype for the launcher Deepa started working on the launcher by attaching it to the base. the base that I built using mecannum wheel and four motors for each and to increase the speed of the motors I used the chains and sprockets. 07/09/2018 Zachary is working on a prototype for the arm's turntable and lifting mechanism. Depending on the length of the lifting mechanism, he should be able to mount the arm on or near a corner of the robot. This should help resolve any mobility and dimension issues presented by the original approach, as well as make loading the launching mechanism easier. The lifting mechanism's concept can be described as "a glorified lever." The extending claw will be ra...
1 comment
Read more
Bergen Community College Robotics Spring Internship 2017 Initially, the old robotics team would like to welcome some of the new members into the team. OLD TEAM NEW TEAM (Members of the old team are only missing from the picture, not the team) Oh and we missed tyler, so here he is...... New Members: Deepa Banjara Alexandra Cortez Tyler Laursen-Carr The BCC STEM Robotics Team is developing a ball launching robot using Autodesk Inventor for design purposes and Robot C for programming purposes. The team has developed 4 major concerns about the design for the robot. First, the robot must gather the balls that are laying on the ground. Second, the robot must feed these balls to an elevator. Third, the elevator must elevate the ball to the launcher. Fourth, the launcher must be able to have varying angles in which it can launch the balls. To account for all of these factors, the designing team had to draw some sketches and ideas on the board for ...
1 comment
Read more